Converged & Hyperconverged Infrastructure

 View Only

 Migration WWN not seen

  • Converged and Hyperconverged Infrastructure
  • Converged and Hyperconverged Infrastructure
Sudhir BISHT's profile image
Sudhir BISHT posted 06-09-2019 02:44

On Hitachi Compute Blade CB500, we are trying to coinfigure LPAR with Migration WWPN. But it is not getting visible to to the SAN switch. So can't do zoning.  How to publish them.

Anyone has faced such issue.  Please advise.

Thanks


#ConvergedandHyperconvergedInfrastructure
Golthier Santos's profile image
Golthier Santos

Not sure if I understood your question but there's few places you can see the WWPN i.e. in the CB500 web GUI, CLI, HBA BIOS. By running the command shown in the example below (blade 0) you should be able collect the info you're looking for.

$show wwn current -b 0

As this is LPAR I'd expect to see the WWN type set to additional.

Sudhir BISHT's profile image
Sudhir BISHT

Thanks.  The above command does shows the WWNs for each blade(total 8 blades).  But this is not what we are looking for.

We are looking for the LPAR Migration WWPNs(or Virtual WWPNs), and those vfc are not visible on SAN.