How do I reset the default IP address of controller 1 from 192.168.0.16 to 10.0.10.10. We just replaced this controller and I need to change IP address to match controller 0. Any help would be greatly appreciated. Thx Walt
Hi Walter. 9500 was end of support many years ago... The default IP of the maintenance port depends on the IP of the management port. The Maintenance port and the management port cannot be on the same LAN.. So changing the Management IP changes the Maintenance IP.
Here are the default IP of the Maintenance Ports:
IP address: LAN port for maintenance on CTL No.0: 10.0.0.16 LAN port for maintenance on CTL No.1: 10.0.0.17
If connection cannot be made, try again with the following IP address. LAN port for maintenance on CTL No.0: 192.168.0.16 LAN port for maintenance on CTL No.1: 192.168.0.17
If none of those work, you can direct connect a PC to the Management Port and use wireshark to see what IP it is. When you powercycle the controller, it will broadcast it's IP.
Retrieving data ...