we have tried moving sfp's, moving DCX ports, dummy replace HUSVM sfp. the port CL1-A seems to be stuck as G-port and wont completely login to fabric.
anyone seen this before?
replaced the sfp with no change, end up replacing the whole CHA-1A and that did the trick.
You may wish to verify the port on HUS VM is set to N_Port mode, other than that, using the Brocade CLI, you can check the Rx power to make sure there is an optical signal coming from the HUS VM - if the Rx power is null, then I suspect you'll need to work with support to ascertain why the port will not login to any port on the switch.
Retrieving data ...