That's good to hear! I'd appreciate it if you marked it as the answer for the next person that might run into the same issue :-)
Original Message:
Sent: 04-25-2024 02:38
From: Nino Gugic
Subject: Adaptive Data Reduction - Analyzer Detail view reports
Hi William,
thank you for your response.
That was a catch, with CMRest configuration.
In the meantime, I also received a response from a Hitachi engineer who send me instructions how to set it up.
Original Message:
Sent: 04-22-2024 03:08
From: William Jansen Van Nieuwenhuizen
Subject: Adaptive Data Reduction - Analyzer Detail view reports
Hello Nino
To get ADR Statistics you need to configure the CMRest connection on the Probe. Can you confirm if it is configured?
If you login to the probe usually https://<ip>:8443/ You'll see the storage. If you click the hyperlink on the name of it you should see if it's configured. If not you'll have to stop the probe, configure it and then start the probe again:
------------------------------
William Jansen Van Nieuwenhuizen
Hitachi Vantara
Original Message:
Sent: 04-18-2024 07:34
From: Nino Gugic
Subject: Adaptive Data Reduction - Analyzer Detail view reports
Hi guys, can somebody help with Analyzer detail view . How can I get Adaptive Data Reduction report, like in the picture below?
This ADR report is shown in this thread : Threat Investigation with Hitachi Ops Center Analyzer 10.8.3 (hitachivantara.com)
But, need help how to get this data in Analyzer Detail View.
Thanks
------------------------------