If you use CCI you can choose the external LUN ID and also the Internal LDEV ID as you would like it.
In HSAe it will default to LUN ID 0 and also LDEV ID whatever is the lowest free LDEV ID.
Add the discovered External Volume
$ raidcom add external_grp -path_grp 1 -external_grp_id 1-1 -port CL1-C -external_iscsi_name iqn.xxx.linux-iscsi.xxs-hsq001-iscsi:port1 -external_address 10.22.124.5 -lun_id 100 or 0 |
or use another LUN ID
Add ldev |
raidcom add ldev -external_grp_id 1-1 -ldev_id 0x0100 -capacity all |
|
|
Name the ldev |
raidcom modify ldev -ldev_id 0x0100 -ldev_name Quorum0 |
|
|
enable Quorum on ldev Primary |
raidcom modify ldev -ldev_id 0x0100 -quorum_enable 61108xx M800 -quorum_id 0 |
|
Check Quorum |
raidcom get quorum |
------------------------------
Matt Muldoon
Systems Engineer
TD SYNNEX Germany GmbH & Co. OHG
------------------------------
Original Message:
Sent: 09-30-2022 12:28
From: Sven Kirsten
Subject: Add External Volume via HSAE - LDEV ID always = 0
When I add a new External Volume via HSAE, I can decide the Path_Group_ID, the Parity_Group, the Name, but I can't decide the LDEV ID !
When I want to use this External Volume for a Quorum Device, the Quorum Device resides always on LDEV ID 0 !
Or are there any options to choose the LDEV ID - I did not see ?
Regards
Sven
------------------------------
Sven Kirsten
Systems Engineer
SVA System Vertrieb Alexander GmbH
------------------------------