Original Message:
Sent: 05-11-2023 08:33
From: William Jansen van Nieuwenhuizen
Subject: CCI RAIDCOM - remote_replica_opt
Hello Sven,
Yes; from the KB:
These values are necessary for setting Blocked Path Monitoring, and are used for TC, TCz, UR, URz, and GAD operations.
------------------------------
William Jansen van Nieuwenhuizen
Hitachi Vantara
Original Message:
Sent: 05-10-2023 09:52
From: Sven Kirsten
Subject: CCI RAIDCOM - remote_replica_opt
Thanks William,
and does this command have the same effect in GAD environemnts ?
regards
Sven
------------------------------
Sven Kirsten
Systems Engineer
SVA System Vertrieb Alexander GmbH
Original Message:
Sent: 05-05-2023 13:03
From: William Jansen van Nieuwenhuizen
Subject: CCI RAIDCOM - remote_replica_opt
Hello Sven
You can review them and what they do here:
https://knowledge.hitachivantara.com/Documents/Management_Software/SVOS/9.8.6/Remote_Replication/Universal_Replicator/05_UR_configuration_operations
Snip-it from the KB:
You can set the period of time to monitor a blocked path and the time to monitor SIMs that are reported by a blocked path using the Edit Remote Replica Options window.You can also change these settings later as needed.Blocked Path Monitoring: range = 2 to 45 secondsBlocked Path SIM Monitoring: range = 2 to 100 secondsTo perform this task in CCI, use the raidcom modify remote_replica_opt command.Setting the maximum initial copy activities optionYou can set the number of volumes that can be copied concurrently during pair creation and pair resynchronization using the Edit Remote Replica Options window (range = 1 to 128, default = 64). You can also change this setting later as needed.To perform this task in CCI, use the raidcom modify remote_replica_opt command.
------------------------------
William Jansen van Nieuwenhuizen
Hitachi Vantara
Original Message:
Sent: 05-05-2023 08:12
From: Sven Kirsten
Subject: CCI RAIDCOM - remote_replica_opt
Hi,
has anyone knowledge about this RAIDCOM subcommand ?
From CCI Reference Guide :
raidcom modify remote_replica_opt { -path_blocked_watch <time(sec)> | -path_blocked_watch_sim <time(sec)>}
-path_blocked_watch <time(sec)>Specifies the path blocked watch time in seconds.-path_blocked_watch_sim <time(sec)>Specifies the path blocked watch SIM time in seconds.
In this description I miss - what does this mean - what does this subcommand do - when should I use this subcommand ?
regards
Sven
------------------------------
Sven Kirsten
Systems Engineer
SVA System Vertrieb Alexander GmbH
------------------------------