Hello Rich
Best would be to go to the node and hit the resize button. Protector should take care of the rest, you should be able to follow what it does in the job log.
One thing you can check before you do it. Is if it will allow you to do the resize without doing a resync of the volume(if this is not tick'ed it should still work but will do a full resync to get the pair in sync again).
Under Storage, check that Replication resize is on 'For new and existing replications'. If you cant toggle this it might be that the protector user you're using doesn't have 'support' privledges to set the mode setting. Make sure to check the setting for both storage arrays.
If it wasn't selected, I find it best to pause & resume the replication first to turn on the setting, then resize it under node as per the first step. But as per the prompt it should do it either way.
Regards
William
------------------------------
William Jansen Van Nieuwenhuizen
Hitachi Vantara
------------------------------
Original Message:
Sent: 05-08-2024 16:10
From: Rich Naber
Subject: Procedure to increase the size of a p_vol in HUR Pair in E590 array.
Procedure to increase the size of a p_vol in HUR Pair in E590 array.
HUR Pair was configured in OPS Center Protector.
------------------------------
Rich Naber
Systems Engineer
Storage IT Solutions
------------------------------