Profile

Antonius-Maria Schwefer

Schwefer Software & Storage

Contact Details

Schwefer Software & Storage

My Content

1 to 5 of 5 total
Posted By Antonius-Maria Schwefer 02-23-2024 05:21
Found In Egroup: Flash Storage​
\ view thread
Hi Jörg, seems to be in TISC only. In Support Portal i couldn´t find it either. ------------------------------ Antonius-Maria Schwefer Systems Engineer Schwefer Software & Storage ------------------------------
Posted By Antonius-Maria Schwefer 02-01-2024 03:29
Found In Egroup: Flash Storage​
\ view thread
when the batteries are discharged, it takes 90 minutes to get 30% charged, which are necessary to start. ------------------------------ Antonius-Maria Schwefer Systems Engineer Schwefer Software & Storage ------------------------------
Posted By Antonius-Maria Schwefer 02-01-2024 03:27
Found In Egroup: Flash Storage​
\ view thread
Hi Ingo, When a power outage occured, the R800 starts a Backup of SM and CM. When power is back and machine is restarted, a restore is done.  Therefor start takes longer than usual. If the DKC is not ready, the SN can`t be startet.  Best regards Toni whem it takes a while firmware ...
Posted By Antonius-Maria Schwefer 02-01-2024 03:17
Found In Egroup: Flash Storage​
\ view thread
------------------------------ Antonius-Maria Schwefer Systems Engineer Schwefer Software & Storage ------------------------------
Posted By Antonius-Maria Schwefer 01-31-2024 08:27
Found In Community: Flash Storage​
\ view thread
Hi Sudhir, it depends on the machine type and the customers requirements: is it  a 2U CBX (VSP G350, VSP E590, VSP E790)?  Then it doesn`t matter from the perspective of redundnacy, whether you take 6D+2P, 12D+2P or 6D+2P. In case of the big controllers, it is possible to install Parity Groups fully ...