Profile

Hi Glauk, just take the URL https:// /ui/#/servers in the browser, where the is the IP of the controller with the active ESM or the Service-IP. Then you will see the Server-Tab temporary again. If you want to make it visible permanently, you have to run a MPC procedure. Cheers Toni ...

Hi Abhishek, that means, a Parity Group should be exclusively used for just one pool. Put all the LDEVs on the same Parity Group in the same pool. In the past some customers wanted to share expensive SSD-Parity Groups by different pools for Tiering. That is a bad idea, because of possible performance ...

Hello Hongbo, Launch Maintenance Utility Install 2xDKBN in slots 1B and 2B via Procedure (will tell you, when to insert them) Mount the DBS2 in the rack, connect Power and SAS cables (dont insert the drives yet) Install Drive Boxes with Maintenance Utility  Insert drives  Install them with Maintenance ...

Hello Sudhir, Microcode Updates are always done by technical people (Hitachi or partners). In the case of any issues, Customers don´t have the skills to troubleshoot. Just trained people know, what they are doing there.  Best regards  Toni ------------------------------ ...

Hi Sven, i would just resync the pair (creating LDEV for 410 in #89) and then delete it again. You can just delete it forcibly, when both volumes are in I/O Mode "blocked" as i know. Best regards  Toni ------------------------------ Antonius Schwefer Non-Hitachi Vantara ------- ...

Hi Shivam, low latency can have many reasons. Is the latency in general high? Where there any changes done in the configuration prior you recognized higher latency? How about Cache Write Pending Rate and Processor utilization? Bests regards Toni

Hi Sven, this is the procedure for Enterprise, described in SVP manual of Maintenance Manuals: Best regards Toni ------------------------------ Antonius Schwefer Non-Hitachi Vantara ------------------------------