Started to receive these messages in the event log after launching an NDMP backup of our Hnas to tape over SAN (NDMP mover aborted). Not sure what this means.
Did you configure the NDMP device list?
I have configured the device list. The Hnas found all 4 tape drives and robot. I set "allow access on any evs" See below. What I haven't done is configured zoning on the SAN switch. Not sure if that makes a difference.
Tapes just need to be in the same zone as the hnas FC port your using.
Has this worked before and suddenly stopped working or is this an installation/setup issue?
This is a new install of Netbackup and first time running NDMP backup of Hitachi to tape.
Retrieving data ...